Cisco Catalyst 2960 Series

To Next Page

To Previous Page

Configuring Static Routing for IPv6: Example

This example shows how to configure a floating static route to an interface with an administrative distance

of 130:

Switch(config)# ipv6 route 2001:0DB8::/32 gigabitethernet2/0/1 130

Displaying IPv6: Example

This is an example of the output from the show ipv6 interface privileged EXEC command:

Switch# show ipv6 interface

Vlan1 is up, line protocol is up

IPv6 is enabled, link-local address is FE80::20B:46FF:FE2F:D940

Global unicast address(es):

3FFE:C000:0:1:20B:46FF:FE2F:D940, subnet is 3FFE:C000:0:1::/64 [EUI]

Joined group address(es):

FF02::1

FF02::2

FF02::1:FF2F:D940

MTU is 1500 bytes

ICMP error messages limited to one every 100 milliseconds

ICMP redirects are enabled

ND DAD is enabled, number of DAD attempts: 1

ND reachable time is 30000 milliseconds

ND advertised reachable time is 0 milliseconds

ND advertised retransmit interval is 0 milliseconds

ND router advertisements are sent every 200 seconds

ND router advertisements live for 1800 seconds

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

197

Configuration Examples for IPv6 Unicast Routing

Other manuals for Cisco Catalyst 2960 Series