Cisco Catalyst 2960 Series User Manual

using an ASCII editor. The script is then copied to the networking device and registered with EEM. When a
policy is registered with the Embedded Event Manager, the software examines the policy and registers it to
be run when the specified event occurs. Policies can be unregistered or suspended. Both types of policies can
be used to implement EEM in your network.
For details on writing EEM policies using the Cisco IOS CLI, go to “Writing Embedded Event Manager
Policies Using the Cisco IOS CLI” module.
For details on writing EEM policies using Tcl, go to “Writing Embedded Event Manager Policies Using Tcl”
module.
Where to Go Next
• If you want to write EEM policies using the Cisco IOS CLI, see the “Writing Embedded Event Manager
Policies Using the Cisco IOS CLI” module.
• If you want to write EEM policies using Tcl, see the “Writing Embedded Event Manager Policies Using
Tcl” module.
Feature Information for Embedded Event Manager 4.0 Overview
The following table provides release information about the feature or features described in this module. This
table lists only the software release that introduced support for a given feature in a given software release
train. Unless noted otherwise, subsequent releases of that software release train also support that feature.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Table 158: Feature Information for Embedded Event Manager 4.0 Overview
Feature InformationReleasesFeature Name
This feature was introduced and is supported only on c2960cx.IOS 15.2(5)E1Embedded Event
Manager 4.0
Additional References
The following sections provide references related to EEM.
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All ReleasesCisco IOS commands
Cisco IOS Embedded Event Manager Command
Reference
EEM commands: complete command syntax, defaults,
command mode, command history, usage guidelines,
and examples
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1679
Where to Go Next

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000