Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(configure-if)# end
Step 10
Verifies your entries.show mls qos aggregate-policer
[aggregate-policer-name]
Step 11
Example:
Switch# show mls qos aggregate-policer
transmit1
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy-running-config startup-config
Step 12
Related Topics
Policing and Marking Overview, on page 550
Examples: Classifying, Policing, and Marking Traffic by Using Aggregate Policers, on page 637
Configuring DSCP Maps
Related Topics
Mapping Tables Overview, on page 552
Configuring the CoS-to-DSCP Map
You use the CoS-to-DSCP map to map CoS values in incoming packets to a DSCP value that QoS uses
internally to represent the priority of the traffic.
Beginning in privileged EXEC mode, follow these steps to modify the CoS-to-DSCP map. This procedure is
optional.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
604
How to Configure QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000