PurposeCommand or Action
Specifies the shared secret text string used between the switch and
all RADIUS servers.
radius-server key string
Example:
Switch(config)# radius-server key
Step 2
The key is a text string that must match the encryption key
used on the RADIUS server. Leading spaces are ignored,
but spaces within and at the end of the key are used. If you
use spaces in your key, do not enclose the key in quotation
marks unless the quotation marks are part of the key.
Note
your_server_key
Specifies the number of times the switch sends each RADIUS request
to the server before giving up. The default is 3; the range 1 to 1000.
radius-server retransmit retries
Example:
Switch(config)# radius-server retransmit
Step 3
5
Specifies the number of seconds a switch waits for a reply to a
RADIUS request before resending the request. The default is 5
seconds; the range is 1 to 1000.
radius-server timeout seconds
Example:
Switch(config)# radius-server timeout
Step 4
3
When a RADIUS server is not responding to authentication requests,
this command specifies a time to stop the request on that server. This
radius-server deadtime minutes
Example:
Switch(config)# radius-server deadtime
Step 5
avoids the wait for the request to timeout before trying the next
configured server. The default is 0; the range is 1 to 1440 minutes.
0
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 6
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 8
startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
927
How to Configure RADIUS
To Next Page
Loading...
Need help?
General
