can register the tm_crash_reporter.tcl policy with EEM using the event manager policy command. Exit from
global configuration mode and enter the show event manager policy registered command to verify that the
policy has been registered.
enable
show event manager policy registered
show event manager policy available
configure terminal
event manager policy tm_crash_reporter.tcl
end
show event manager policy registered
Running the tm_fsys_usage.tcl Sample Policy
This sample policy demonstrates the ability to periodically monitor disk space usage and report through syslog
when configurable thresholds have been crossed.
The following sample configuration demonstrates how to use this policy. Starting in user EXEC mode, enter
the enable command at the device prompt. The device enters privileged EXEC mode, where you can enter
the show event manager policy registered command to verify that no policies are currently registered. The
next command is the show event manager policy available command to display which policies are available
to be installed. After you enter the configure terminal command to reach global configuration mode, you
can register the tm_fsys_usage.tcl policy with EEM using the event manager policy command. Exit from
global configuration mode and enter the show event manager policy registered command again to verify
that the policy has been registered. If you had configured any of the optional environment variables that are
used in the tm_fsys_usage.tcl policy, the show event manager environment command displays the configured
variables.
enable
show event manager policy registered
show event manager policy available
configure terminal
event manager policy tm_fsys_usage.tcl
end
show event manager policy registered
show event manager environment
Programming Policies with Tcl Sample Scripts Example
This section contains some of the sample policies that are included as EEM system policies. For more details
about these policies, see the EEM Event Detector Demo Examples, on page 1802.
Mandatory.go_ipsec.tcl Sample Policy
The following sample policy for the TestIPSecEncrypDecrypPkt Test.
::cisco::eem::event_register_gold card all testing_type monitoring test_name Tes
tIPSecEncrypDecrypPkt consecutive_failure 6 platform_action 0 queue_priority las
t
#
# GOLD TestIPSecEncrypDecrypPkt Test TCL script
#
# March 2005, Hai Qiu
#
# Copyright (c) 2005-2007 by cisco Systems, Inc.
# All rights reserved.
#
#
# Register for TestIPSecEncrypDecrypPkt test even
# the elements for register the event
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1811
Configuration Examples for Writing Embedded Event Manager Policies Using Tcl