Configuring Dynamic-Access Ports on VMPS Clients
Dynamic-access port VLAN membership is for end stations or hubs connected to end stations. Connecting
dynamic-access ports to other switches can cause a loss of connectivity.
Caution
If you are configuring a port on a cluster member switch as a dynamic-access port, first use the rcommand
privileged EXEC command to log in to the cluster member switch.
Before You Begin
You must have IP connectivity to the VMPS for dynamic-access ports to work. You can test for IP connectivity
by pinging the IP address of the VMPS and verifying that you get a response.
To return an interface to its default configuration, use the default interface interface-id interface
configuration command. To return an interface to its default switchport mode (dynamic auto), use the no
switchport mode interface configuration command. To reset the access mode to the default VLAN for
the switch, use the no switchport access vlan interface configuration command.
Note
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
switchport mode access
5.
switchport access vlan dynamic
6.
end
7.
show interfaces interface-id switchport
8.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2156
How to Configure VMPS
To Next Page
Loading...
Need help?
General
