•
Verifies that each of these intercepted packets has a valid IP-to-MAC address binding before updating
the local ARP cache or before forwarding the packet to the appropriate destination
•
Drops invalid ARP packets
Dynamic ARP inspection determines the validity of an ARP packet based on valid IP-to-MAC address bindings
stored in a trusted database, the DHCP snooping binding database. This database is built by DHCP snooping
if DHCP snooping is enabled on the VLANs and on the switch. If the ARP packet is received on a trusted
interface, the switch forwards the packet without any checks. On untrusted interfaces, the switch forwards
the packet only if it is valid.
You enable dynamic ARP inspection on a per-VLAN basis by using the ip arp inspection vlan vlan-range
global configuration command.
In non-DHCP environments, dynamic ARP inspection can validate ARP packets against user-configured ARP
access control lists (ACLs) for hosts with statically configured IP addresses. You define an ARP ACL by
using the arp access-list acl-name global configuration command.
You can configure dynamic ARP inspection to drop ARP packets when the IP addresses in the packets are
invalid or when the MAC addresses in the body of the ARP packets do not match the addresses specified in
the Ethernet header. Use the ip arp inspection validate {[src-mac] [dst-mac] [ip]} global configuration
command.
Interface Trust States and Network Security
Dynamic ARP inspection associates a trust state with each interface on the switch. Packets arriving on trusted
interfaces bypass all dynamic ARP inspection validation checks, and those arriving on untrusted interfaces
undergo the dynamic ARP inspection validation process.
In a typical network configuration, you configure all switch ports connected to host ports as untrusted and
configure all switch ports connected to switches as trusted. With this configuration, all ARP packets entering
the network from a given switch bypass the security check. No other validation is needed at any other place
in the VLAN or in the network. You configure the trust setting by using theip arp inspection trust interface
configuration command.
Use the trust state configuration carefully. Configuring interfaces as untrusted when they should betrusted
can result in a loss of connectivity.
Caution
In the following figure, assume that both Switch A and Switch B are running dynamic ARP inspection on the
VLAN that includes Host 1 and Host 2. If Host 1 and Host 2 acquire their IP addresses from the DHCP server
connected to Switch A, only Switch A binds the IP-to-MAC address of Host 1. Therefore, if the interface
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1302
Understanding Dynamic ARP Inspection
To Next Page
Loading...
Need help?
General
