DescriptionAttributeSub-Type NumberVendor-Specific
Company Code
Number
Specifies the maximum
receive window size for
L2TP control messages.
This value is advertised to
the peer during tunnel
establishment.
l2tp-cm-local-window-size1926
Respects sequence
numbers on data packets
by dropping those that are
received out of order. This
does not ensure that
sequence numbers will be
sent on data packets, just
how to handle them if they
are received.
l2tp-drop-out-of-order1926
Specifies the number of
seconds for the hello
keepalive interval. Hello
packets are sent when no
data has been sent on a
tunnel for the number of
seconds configured here.
l2tp-hello-interval1926
When enabled, sensitive
AVPs in L2TP control
messages are scrambled or
hidden.
l2tp-hidden-avp1926
Specifies the number of
seconds that a tunnel will
stay active with no
sessions before timing out
and shutting down.
l2tp-nosession-timeout1926
Copies the IP ToS field
from the IP header of each
payload packet to the IP
header of the tunnel packet
for packets entering the
tunnel at the LNS.
tunnel-tos-reflect1926
If this attribute is set, it
performs L2TP tunnel
authentication.
l2tp-tunnel-authen1926
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
909
Information about RADIUS