Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Verifies your entries.show access-lists
Example:
Switch# show access-lists
Step 4
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy-running-config
Step 5
startup-config
Related Topics
Access Control Lists, on page 548
QoS ACL Guidelines, on page 540
Examples: Classifying Traffic by Using ACLs, on page 631
Creating an IP Extended ACL for IPv4 Traffic
Before You Begin
Before you perform this task, determine which access lists you will be using for your QoS configuration.
SUMMARY STEPS
1.
configure terminal
2.
access-list access-list-number {deny | permit} protocol source source-wildcard destination
destination-wildcard
3.
end
4.
show access-lists
5.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Creates an IP extended ACL, repeating the command as many times as necessary.
access-list access-list-number {deny |
permit} protocol source
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
586
How to Configure QoS

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000