Cisco Catalyst 2960 Series User Manual

Feature InformationReleasesFeature Name
The Secure Shell Version 2 Support feature
allows you to configure Secure Shell (SSH)
Version 2 (SSH Version 1 support was
implemented in an earlier Cisco software
release). SSH runs on top of a reliable
transport layer and provides strong
authentication and encryption capabilities.
This feature was supported on CAT2960,
CAT3560E, CAT3560X, CAT3750,
CAT3750E, CAT3750X, CAT4500.
The following commands were introduced
or modified: debug ip ssh, ip ssh min dh
size, ip ssh rsa keypair-name, ip ssh
version, and ssh.
Cisco IOS XE Release
3.4SG
Secure Shell Version 2 Support
The SSH Keyboard Interactive
Authentication feature, also known as
Generic Message Authentication for SSH,
is a method that can be used to implement
different types of authentication
mechanisms. Basically, any currently
supported authentication method that
requires only user input can be performed
with this feature.
This feature was supported on CAT2960,
CAT3560E, CAT3560X, CAT3750,
CAT3750E, CAT3750X, CAT4500.
Cisco IOS XE Release
3.4SG
SSH Keyboard Interactive
Authentication
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1115
Feature Information for Secure Shell Version 2 Support

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000