Cisco Catalyst 2960 Series User Manual

Displaying Embedded Event Manager History Data
Perform this optional task to change the size of the history tables and to display EEM history data.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
event manager history size {events | traps} [size]
4.
exit
5.
show event manager history events [detailed] [maximum number]
6.
show event manager history traps {server | policy}
DETAILED STEPS
Step 1
enable
Enables privileged EXEC mode. Enter your password if prompted.
Example:
Device> enable
Step 2
configure terminal
Enters global configuration mode.
Example:
Device# configure terminal
Step 3
event manager history size {events | traps} [size]
Use this command to change the size of the EEM event history table or the size of the EEM SNMP trap history table.
In the following example, the size of the EEM event history table is changed to 30 entries:
Example:
Device(config)# event manager history size events 30
Step 4
exit
Exits global configuration mode and returns to privileged EXEC mode.
Example:
Device(config)# exit
Step 5
show event manager history events [detailed] [maximum number]
Use this command to display detailed information about each EEM event, for example:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1706
How to Write EEM Policies Using the Cisco IOS CLI

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000