This error means that the time specified to arm a timer was zero.
(_cerr_sub_err = 42) FH_ENOTREGISTERED (request for event spec that is unregistered)
This error means that the event was not registered.
(_cerr_sub_err = 54) FH_EFDUNAVAIL (connection to event detector unavailable)
This error means that the event detector was unavailable.
(_cerr_sub_err = 56) FH_EFDCONNERR (event detector connection error)
This error means that the EEM event detector that handles this request is not available.
timer_cancel
Cancels a timer.
Syntax
timer_cancel event_id ?
Arguments
(Mandatory) The timer event ID returned by the
register_timer command extension. Must be an
integer between 0 and 4294967295, inclusive.
event_id
Result String
sec_remain %ld msec_remain %ld
Where sec_remain and msec_remain are the remaining time before the next expiration of the timer.
A value of 0 will be returned for sec_remain and msec_remain if the timer type is CRON .Note
Set _cerrno
Yes
(_cerr_sub_err = 2) FH_ESYSERR (generic/unknown error from OS/system)
This error means that the operating system reported an error. The POSIX errno value that is reported with the
error should be used to determine the cause of the operating system error.
(_cerr_sub_err = 6) FH_EBADEVENTTYPE (unknown EEM event type)
This error means that the event type specified in the internal event specification was invalid.
(_cerr_sub_err = 7) FH_ENOSUCHKEY (could not find key)
This error means that the application event detector info key or other ID was not found.
(_cerr_sub_err = 11) FH_ENOSUCHESID (unknown event specification ID)
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2019
timer_cancel
To Next Page
Loading...
Need help?
General
