Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
•
hh:mm:ss—Specifies the time in hours (24-hour format), minutes,
and seconds. The time specified is relative to the configured time
zone.
•
clock set hh:mm:ss day month year
•
clock set hh:mm:ss month day year
•
day—Specifies the day by date in the month.
Example:
Switch# clock set 13:32:00 23 March 2013
•
month—Specifies the month by name.
•
year—Specifies the year (no abbreviation).
Configuring the Time Zone
Follow these steps to manually configure the time zone:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
clock timezone zone hours-offset [minutes-offset]
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Sets the time zone.
clock timezone zone hours-offset
[minutes-offset]
Step 3
Internal time is kept in Coordinated Universal Time (UTC), so this
command is used only for display purposes and when the time is
manually set.
Example:
Switch(config)# clock timezone AST -3 30
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1532
How to Administer the Switch

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000