CHAPTER 88
Configuring VMPS
•
Finding Feature Information, page 2151
•
Prerequisites for VMPS, page 2151
•
Restrictions for VMPS, page 2152
•
Information About VMPS, page 2152
•
How to Configure VMPS, page 2154
•
Monitoring the VMPS, page 2161
•
Configuration Example for VMPS, page 2162
•
Where to Go Next, page 2163
•
Additional References, page 2164
•
Feature History and Information for VMPS, page 2165
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for VMPS
You should configure the VLAN Membership Policy Server (VMPS) before you configure ports as
dynamic-access ports.
When you configure a port as a dynamic-access port, the spanning-tree Port Fast feature is automatically
enabled for that port. The Port Fast mode accelerates the process of bringing the port into the forwarding state.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2151