Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 9
Make sure that you have reestablished the connection
between the switch and the event connection by
examining the output from show cns event connections.
Step 10
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 11
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 12
Related Topics
Hostname and DeviceID, on page 411
Enabling a Partial Configuration for Cisco IOS CNS Agent
Follow these steps to enable the Cisco IOS CNS agent and to initiate a partial configuration on the switch.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
cns config partial {ip-address | hostname} [port-number] [source ip-address]
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
425
How to Configure the Configuration Engine

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000