DescriptionEnvironment Variable
The time identifier of subevents._wd_sub1_entry_ [1-N]_b_tid
_wd_sub2_entry_[1-N]_b_tid
The slot number for the subevent RP reporting node._wd_sub1_entry_ [1-N]_node
_wd_sub2_entry_[1-N]_node
The process identifier of subevents._wd_sub1_entry_ [1-N]_pid
_wd_sub2_entry_[1-N]_pid
The process name of subevents._wd_sub1_entry_ [1-N]_procname
_wd_sub2_entry_[1-N]_procname
The time identifier of subevents._wd_sub1_entry_ [1-N]_state
_wd_sub2_entry_[1-N]_state
The time identifier of subevents._wd_sub1_entry_ [1-N]_tid
_wd_sub2_entry_[1-N]_tid
The number of subevents._wd_sub1_num_entries _wd_sub2_num_entries
Watchdog System Monitor (WDSysMon) dispatch
manager Subevents
The slot number for the subevent RP reporting node._wd_sub1_node _wd_sub2_node
The time period, in seconds and optional milliseconds,
used for measurement in subevents.
_wd_sub1_period _wd_sub2_period
The process name of subevents._wd_sub1_procname _wd_sub2_procname
The CPU utilization of subevents measured as a
percentage.
_wd_sub1_value _wd_sub2_value
Watchdog System Monitor (WDSysMon) mem_proc
Subevents
A percentage value of the difference that triggered
the event.
This variable is set only when the
_wd_sub1_is_percent or
_wd_sub2_is_percent variable contains a
value of 1.
Note
_wd_sub1_diff _wd_sub2_diff
A number that identifies whether the value is a
percentage. A value of 0 means that the value is not
a percentage; a value of 1 means that the value is a
percentage.
_wd_sub1_is_percent _wd_sub2_is_percent
The slot number for the subevent RP reporting node._wd_sub1_node _wd_sub2_node
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1695
Information About Writing EEM Policies Using the Cisco IOS CLI
To Next Page
Loading...
Need help?
General
