Cisco Catalyst 2960 Series

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
power inline port 2-event
5.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the physical port to be configured, and enters
interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet2/0/1
Step 3
Configures 2-event classification on the switch.power inline port 2-event
Example:
Switch(config-if)# power inline port 2-event
Step 4
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
Related Topics
Example: Configuring 2-Event Classification, on page 105
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
104
Configuring 2-event Classification