Type escape sequence to abort.
Sending 5, 100-byte ICMP Echoes to 172.20.52.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
Switch#
Table 153: Ping Output Display Characters
DescriptionCharacter
Each exclamation point means receipt of a reply.!
Each period means the network server timed out while
waiting for a reply.
.
A destination unreachable error PDU was received.U
A congestion experienced packet was received.C
User interrupted test.I
Unknown packet type.?
Packet lifetime exceeded.&
To end a ping session, enter the escape sequence (Ctrl-^ X by default). Simultaneously press and release the
Ctrl, Shift, and 6 keys and then press the X key.
Related Topics
Ping, on page 1627
Executing Ping, on page 1643
Example: Performing a Traceroute to an IP Host
This example shows how to perform a traceroute to an IP host:
Switch# traceroute ip 192.0.2.10
Type escape sequence to abort.
Tracing the route to 192.0.2.10
1 192.0.2.1 0 msec 0 msec 4 msec
2 192.0.2.203 12 msec 8 msec 0 msec
3 192.0.2.100 4 msec 0 msec 0 msec
4 192.0.2.10 0 msec 4 msec 0 msec
The display shows the hop count, the IP address of the router, and the round-trip time in milliseconds for each
of the three probes that are sent.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1653
Configuration Examples for Troubleshooting Software
To Next Page
Loading...
Need help?
General
