Cisco Catalyst 2960 Series User Manual

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
snmp-server host host-addr community-string notification-type { informs | traps } {version {1 | 2c | 3}}
{vrf vrf instance name}
4.
snmp-server enable traps mac-notification change
5.
mac address-table notification change
6.
mac address-table notification change [interval value] [history-size value]
7.
interface interface-id
8.
snmp trap mac-notification change {added | removed}
9.
end
10.
show running-config
11.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the recipient of the trap message.
snmp-server host host-addr community-string
notification-type { informs | traps } {version {1
| 2c | 3}} {vrf vrf instance name}
Step 3
•
host-addr—Specifies the name or address of the NMS.
Example:
Switch(config)# snmp-server host
172.20.10.10 traps private mac-notification
•
traps (the default)—Sends SNMP traps to the host.
•
informs—Sends SNMP informs to the host.
•
version—Specifies the SNMP version to support. Version 1,
the default, is not available with informs.
•
community-string—Specifies the string to send with the
notification operation. Though you can set this string by using
the snmp-server host command, we recommend that you
define this string by using the snmp-server community
command before using the snmp-server host command.
•
notification-type—Uses the mac-notification keyword.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1544
How to Administer the Switch

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000