PurposeCommand or Action
startup-config
Configuring MVR Interfaces
Follow these steps to configure Layer 2 MVR interfaces:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
mvr
4.
interface interface-id
5.
mvr type {source | receiver}
6.
mvr vlan vlan-id group [ip-address]
7.
mvr immediate
8.
end
9.
Use one of the following:
•
show mvr
•
show mvr interface
•
show mvr members
10.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
149
How to Configure IGMP Snooping and MVR
To Next Page
Loading...
