Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Enables MLD snooping on the switch.ipv6 mld snooping
Example:
Switch(config)# ipv6 mld snooping
Step 2
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 3
(Optional) Save your entries in the configuration
file.
copy running-config startup-config
Example:
Switch(config)# copy running-config startup-config
Step 4
Reload the operating system.reload
Example:
Switch(config)# reload
Step 5
Enabling or Disabling MLD Snooping on a VLAN (CLI)
Beginning in privileged EXEC mode, follow these steps to enable MLD snooping on a VLAN.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enables MLD snooping on the switch.ipv6 mld snooping
Example:
Switch(config)# ipv6 mld snooping
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
175
How to Configure IPv6 MLD Snooping

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000