EasyManuals Logo

Cisco Catalyst 2960 Series User Manual

Cisco Catalyst 2960 Series
2288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1158 background imageLoading...
Page #1158 background image
PurposeCommand or Action
example, if the SSH client supports SSHv1 and SSHv2, the SSH server
selects SSHv2.
Configures the SSH control parameters:
ip ssh {timeout seconds |
authentication-retries number}
Step 4
Specify the time-out value in seconds; the default is 120 seconds.
The range is 0 to 120 seconds. This parameter applies to the SSH
Example:
Switch(config)# ip ssh timeout 90
negotiation phase. After the connection is established, the Switch
uses the default time-out values of the CLI-based sessions.
authentication-retries 2
By default, up to five simultaneous, encrypted SSH connections for
multiple CLI-based sessions over the network are available (session
0 to session 4). After the execution shell starts, the CLI-based session
time-out value returns to the default of 10 minutes.
Specify the number of times that a client can re-authenticate to the
server. The default is 3; the range is 0 to 5.
Repeat this step when configuring both parameters.
(Optional) Configures the virtual terminal line settings.Use one or both of the following:
Step 5
line
vtyline_number[ ending_line_number ]
Enters line configuration mode to configure the virtual terminal line
settings. For line_number and ending_line_number, specify a pair
of lines. The range is 0 to 15.
transport input ssh
Specifies that the Switch prevent non-SSH Telnet connections. This
limits the router to only SSH connections.
Example:
Switch(config)# line vty 1 10
or
Switch(config-line)# transport input
ssh
Returns to privileged EXEC mode.end
Example:
Switch(config-line)# end
Step 6
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 8
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1076
How to Configure Secure Shell

Table of Contents

Other manuals for Cisco Catalyst 2960 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960 Series and is the answer not in the manual?

Cisco Catalyst 2960 Series Specifications

General IconGeneral
LayerLayer 2
Power over Ethernet (PoE)Available on some models
RAM128 MB
Flash Memory32 MB
MAC Address Table Size8000
Operating Temperature0°C to 45°C (32 to 113°F)
Ports24 or 48 x 10/100/1000

Related product manuals