Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Uses the IP address of a specified interface for all
outgoing TACACS+ packets.
ip tacacs source-interface subinterface-name
Example:
Device(config-sg-tacacs+)# ip tacacs
source-interface Loopback0
Step 13
Exits server-group configuration mode.exit
Example:
Device(config-sg-tacacs)# exit
Step 14
Verifying Per VRF for TACACS Servers
To verify the per VRF TACACS+ configuration, perform the following steps:
The debug commands may be used in any order.Note
SUMMARY STEPS
1.
enable
2.
debug tacacs authentication
3.
debug tacacs authorization
4.
debug tacacs accounting
5.
debug tacacs packets
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Displays information about AAA/TACACS+
authentication.
debug tacacs authentication
Example:
Device# debug tacacs authentication
Step 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
894
How to Configure TACACS+

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000