Cisco Catalyst 2960 Series User Manual

PurposeCommand or Action
Example:
Switch# configure terminal
Enables the switch to obtain and processes the MAC
address-table move updates.
mac address-table move update receive
Example:
Switch (config)# mac address-table move update
Step 2
receive
Returns to privileged EXEC mode.end
Example:
Switch (config)# end
Step 3
Related Topics
Monitoring Flex Links, Multicast Fast Convergence, and MAC Address-Table Move Update, on page
386
Configuring the MAC Address-Table Move Update: Examples, on page 389
MAC Address-Table Move Update, on page 377
Restrictions for Configuring Flex Links and MAC Address-Table Move Update, on page 373
Configuring the MAC Address-Table Move Update: Examples, on page 389
Monitoring Flex Links, Multicast Fast Convergence, and MAC Address-Table
Move Update
PurposeCommand
Displays the Flex Links backup interface configured for an interface
or all the configured Flex Links and the state of each active and
backup interface (up or standby mode).
show interface [interface-id]
switchport backup
Displays the specified IGMP profile or all the IGMP profiles
defined on the switch.
show ip igmp profile address-table
move update profile-id
Displays the MAC address-table move update information on the
switch.
show mac address-table move update
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
386
Monitoring Flex Links, Multicast Fast Convergence, and MAC Address-Table Move Update

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000