PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 8
What to Do Next
To disable MAC address-move notification traps, use the no snmp-server enable traps mac-notification
move global configuration command. To disable the MAC address-move notification feature, use the no mac
address-table notification mac-move global configuration command.
You can verify your settings by entering the show mac address-table notification mac-move privileged
EXEC commands.
Configuring MAC Threshold Notification Traps
When you configure MAC threshold notification, an SNMP notification is generated and sent to the network
management system when a MAC address table threshold limit is reached or exceeded.
Follow these steps to configure the switch to send MAC address table threshold notification traps to an NMS
host:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
snmp-server host host-addr {traps | informs} {version {1 | 2c | 3}} community-string notification-type
4.
snmp-server enable traps mac-notification threshold
5.
mac address-table notification threshold
6.
mac address-table notification threshold [limit percentage] | [interval time]
7.
end
8.
show running-config
9.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1548
How to Administer the Switch
To Next Page
Loading...
Need help?
General
