PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 6
The show spanning-tree interface interface-id privileged EXEC command displays information only for
ports that are in a link-up operative state. Otherwise, you can use the show running-config privileged EXEC
command to confirm the configuration.
Related Topics
Port Priority Versus Path Cost, on page 215
Configuring the Device Priority of a VLAN
You can configure the switch priority and make it more likely that a standalone switch or a switch in the stack
will be chosen as the root switch.
Exercise care when using this command. For most situations, we recommend that you use the spanning-tree
vlan vlan-id root primary and the spanning-tree vlan vlan-id root secondary global configuration
commands to modify the switch priority.
Note
This procedure is optional.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
spanning-tree vlan vlan-id priority priority
4.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Example:
Switch> enable
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
233
How to Configure Spanning-Tree Features
To Next Page
Loading...
Need help?
General
