Cisco Catalyst 2960 Series User Manual

12.212.112.011.311.211.111.0DescriptionAttribute
yesyesyesyesnononoSpecifies an
input SAP
filter access
list definition
to be
installed and
applied on
the current
interface for
the duration
of the
current
connection.
Used with
service=ppp
and
protocol=ipx.
sap-fltr-in#<n>
yesyesyesyesnononoSpecifies an
output SAP
filter access
list definition
to be
installed and
applied on
the current
interface for
the duration
of the
current
connection.
Used with
service=ppp
and
protocol=ipx.
sap-fltr-out#<n>
yesyesnononononoDefines the
protocol to
use (PAP or
CHAP) for
username-password
authentication
following
CLID
authentication.
Used with
service=any
and
protocol=aaa.
send-auth
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
811
Information About TACACS+

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000