Cisco Catalyst 2960 Series User Manual

•
output_errors--Sum of all errors that prevented
the final transmission of datagrams out of the
interface being examined. Note that this may
not balance with the sum of the enumerated
output errors, because some datagrams may
have more than one error, and others may have
errors that do not fall into any of the specifically
tabulated categories.
•
output_errors_underrun--Number of times that
the transmitter has been running faster than the
device can handle.
•
output_packets_dropped--Number of packets
dropped because of a full output queue.
•
receive_broadcasts--Number of broadcast or
multicast packets received by the interface.
•
receive_giants--Number of packets that are
discarded because they exceed the maximum
packet size of the medium.
•
receive_rate_bps--Interface receive rate in bytes
per second.
•
receive_rate_pps--Interface receive rate in
packets per second.
•
receive_runts--Number of packets that are
discarded because they are smaller than the
minimum packet size of the medium.
•
receive_throttle--Number of times that the
receiver on the port was disabled, possibly
because of buffer or processor overload.
•
reliability--Reliability of the interface as a
fraction of 255 (255/255 is 100 percent
reliability), calculated as an exponential average
over 5 minutes.
•
rxload--Receive rate of the interface as a
fraction of 255 (255/255 is 100 percent).
•
transmit_rate_bps--Interface transmit rate in
bytes per second.
•
transmit_rate_pps--Interface transmit rate in
packets per second.
•
txload--Transmit rate of the interface as a
fraction of 255 (255/255 is 100 percent).
parameter (continued)
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1891
event_register_interface

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000