Cisco Catalyst 2960 Series User Manual

Spanning-Tree Topology and BPDUs
The stable, active spanning-tree topology of a switched network is controlled by these elements:
•
The unique bridge ID (switch priority and MAC address) associated with each VLAN on each switch.
In a switch stack, all switches use the same bridge ID for a given spanning-tree instance.
•
The spanning-tree path cost to the root switch.
•
The port identifier (port priority and MAC address) associated with each Layer 2 interface.
When the switches in a network are powered up, each functions as the root switch. Each switch sends a
configuration BPDU through all of its ports. The BPDUs communicate and compute the spanning-tree topology.
Each configuration BPDU contains this information:
•
The unique bridge ID of the switch that the sending switch identifies as the root switch
•
The spanning-tree path cost to the root
•
The bridge ID of the sending switch
•
Message age
•
The identifier of the sending interface
•
Values for the hello, forward delay, and max-age protocol timers
When a switch receives a configuration BPDU that contains superior information (lower bridge ID, lower
path cost, and so forth), it stores the information for that port. If this BPDU is received on the root port of the
switch, the switch also forwards it with an updated message to all attached LANs for which it is the designated
switch.
If a switch receives a configuration BPDU that contains inferior information to that currently stored for that
port, it discards the BPDU. If the switch is a designated switch for the LAN from which the inferior BPDU
was received, it sends that LAN a BPDU containing the up-to-date information stored for that port. In this
way, inferior information is discarded, and superior information is propagated on the network.
A BPDU exchange results in these actions:
•
One switch in the network is elected as the root switch (the logical center of the spanning-tree topology
in a switched network). See the figure following the bullets.
For each VLAN, the switch with the highest switch priority (the lowest numerical priority value) is
elected as the root switch. If all switches are configured with the default priority (32768), the switch
with the lowest MAC address in the VLAN becomes the root switch. The switch priority value occupies
the most significant bits of the bridge ID, as shown in the following figure.
•
A root port is selected for each switch (except the root switch). This port provides the best path (lowest
cost) when the switch forwards packets to the root switch.
•
Only one outgoing port on the stack root switch is selected as the root port. The remaining switches in
the stack become its designated switches (Switch 2 and Switch 3) as shown in the following figure.
•
The shortest distance to the root switch is calculated for each switch based on the path cost.
•
A designated switch for each LAN segment is selected. The designated switch incurs the lowest path
cost when forwarding packets from that LAN to the root switch. The port through which the designated
switch is attached to the LAN is called the designated port.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
213
Information About Spanning Tree Protocol

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000