Cisco Catalyst 2960 Series

PurposeCommand or Action
•
ipv6 nd inspection [attach-policy policy_name [ vlan
{ add | except | none | remove | all} vlan [ vlan1,
vlan2, vlan3...]]]
Exists the interface configuration mode.exit
Step 4
Related Topics
Information about First Hop Security in IPv6, on page 678
How to Configure an IPv6 Router Advertisement Guard Policy
Beginning in privileged EXEC mode, follow these steps to configure an IPv6 Router Advertisement policy :
SUMMARY STEPS
1.
configure terminal
2.
[no]ipv6 nd raguard policy policy-name
3.
[no]device-role {host | monitor | router | switch}
4.
[no]hop-limit {maximum | minimum} value
5.
[no]managed-config-flag {off | on}
6.
[no]match {ipv6 access-list list | ra prefix-list list}
7.
[no]other-config-flag {on | off}
8.
[no]router-preference maximum {high | medium | low}
9.
[no]trusted-port
10.
default {device-role | hop-limit {maximum | minimum} | managed-config-flag | match {ipv6 access-list
| ra prefix-list } | other-config-flag | router-preference maximum| trusted-port}
11.
do show ipv6 nd raguard policy policy_name
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
695
How to Configure an IPv6 Router Advertisement Guard Policy