CHAPTER 68
Configuring Online Diagnostics
•
Information About Configuring Online Diagnostics, page 1613
•
How to Configure Online Diagnostics, page 1614
•
Monitoring and Maintaining Online Diagnostics, page 1618
•
Configuration Examples for Online Diagnostic Tests, page 1619
•
Additional References for Online Diagnostics, page 1622
•
Feature History and Information for Configuring Online Diagnostics, page 1623
Information About Configuring Online Diagnostics
Online Diagnostics
With online diagnostics, you can test and verify the hardware functionality of the Switch while the Switch is
connected to a live network.
The online diagnostics contain packet switching tests that check different hardware components and verify
the data path and the control signals.
The online diagnostics detect problems in these areas:
•
Hardware components
•
Interfaces (Ethernet ports and so forth)
•
Solder joints
Online diagnostics are categorized as on-demand, scheduled, or health-monitoring diagnostics. On-demand
diagnostics run from the CLI; scheduled diagnostics run at user-designated intervals or at specified times
when the Switch is connected to a live network; and health-monitoring runs in the background with user-defined
intervals. By default, the health-monitoring test runs for every 30 seconds.
After you configure online diagnostics, you can manually start diagnostic tests or display the test results. You
can also see which tests are configured for the Switch or switch stack and the diagnostic tests that have already
run.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1613
To Next Page
Loading...
Need help?
General
