Cisco Catalyst 2960 Series User Manual

(Mandatory) Abnormal process termination. Process
may abort because of exiting with a nonzero exit
status, receiving a kernel-generated signal, or
receiving a SIGTERM or SIGKILL signal that is not
sent because of user request.
abort
(Mandatory) Normal process termination.term
(Mandatory) Process start.start
(Mandatory) Process termination due to the process
restart request from the CLI command.
user_restart
(Mandatory) Process termination due to the process
kill request from the CLI command.
user_shutdown
(Optional) Number assigned to the EEM policy that
published the process event. Number is set to 798
because all other numbers are reserved for Cisco use.
sub_system
(Optional) Version number of the process assigned
by the version manager. Must be of the form
major_number.minor_number.level. If specified, each
component of the version number must be an integer
between 1 and 4294967295, inclusive.
version
(Optional) Process instance ID. If specified, this
argument must be an integer between 1 and
4294967295, inclusive.
instance
(Optional) Process pathname (a regular expression
string). If the value of the process-name argument
contains embedded blanks, enclose it in double
quotation marks. Use path ".*" to match all processes.
path
(Optional) The node name is a string that consists of
the word "node" followed by two fields separated by
a slash character using the following format:
node<slot-number>/<cpu-number>
The slot-number is the hardware slot number. The
cpu-number is the hardware CPU number. For
example, the SP CPU in a Supervisor card on a Cisco
Catalyst 6500 series switch located in slot 0 would
be specified as node0/0. The RP CPU in a Supervisor
card on a Cisco Catalyst 6500 series switch located
in slot 0 would be addressed as node0/1. If the node
argument is not specified, the default node
specification is always the regular expression pattern
match of * representing all applicable nodes.
node
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1919
event_register_process

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000