Cisco Catalyst 2960 Series

Queues and WTD Thresholds 562
Shaped or Shared Mode 562
Packet Modification 563
Standard QoS Default Configuration 563
Default Ingress Queue Configuration 564
Default Egress Queue Configuration 565
Default Mapping Table Configuration 568
DSCP Maps 568
Default CoS-to-DSCP Map 568
Default IP-Precedence-to-DSCP Map 569
Default DSCP-to-CoS Map 570
How to Configure QoS 571
Enabling QoS Globally 571
Enabling VLAN-Based QoS on Physical Ports 572
Configuring Classification Using Port Trust States 573
Configuring the Trust State on Ports Within the QoS Domain 574
Configuring the CoS Value for an Interface 576
Configuring a Trusted Boundary to Ensure Port Security 578
Enabling DSCP Transparency Mode 580
DSCP Transparency Mode 581
Configuring the DSCP Trust State on a Port Bordering Another QoS Domain 582
Configuring a QoS Policy 584
Classifying Traffic by Using ACLs 584
Creating an IP Standard ACL for IPv4 Traffic 584
Creating an IP Extended ACL for IPv4 Traffic 586
Creating an IPv6 ACL for IPv6 Traffic 588
Creating a Layer 2 MAC ACL for Non-IP Traffic 590
Classifying Traffic by Using Class Maps 592
Classifying Traffic by Using Class Maps and Filtering IPv6 Traffic 595
Classifying, Policing, and Marking Traffic on Physical Ports by Using Policy
Maps 597
Classifying, Policing, and Marking Traffic by Using Aggregate Policers 601
Configuring DSCP Maps 604
Configuring the CoS-to-DSCP Map 604
Configuring the IP-Precedence-to-DSCP Map 606
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
xxv
Contents