C613-50100-01 REV C Command Reference for x930 Series 1865
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST (HARDWARE IP NUMBERED)
permit The access-list permits packets that match the type, source, and
destination filtering specified with this command.
send-to-cpu Specify packets to send to the CPU.
tcp The access-list matches only TCP packets.
udp The access-list matches only UDP packets.
<source> The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
any Matches any source IP address.
host<ip-addr> Matches a single source host
with the IP address given by <ip-
addr> in dotted decimal
notation.
<ip-addr>/<prefix> An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255 is
the same as entering
192.168.1.1/24.
<destination> The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any Matches any destination IP
address.
host<ip-addr> Matches a single destination host
with the IP address given by
<ip-addr> in dotted decimal
notation.
<ip-addr>/<prefix> An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within the
specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255 is
the same as entering
192.168.1.1/24.
Table 39: Parameters in the access-list (hardware IP numbered) command -
tcp|udp (cont.)
Parameter Description
To Next Page
Loading...
