Allied Telesis AlliedWare Plus - Page 1864

C613-50100-01 REV C Command Reference for x930 Series 1864
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST (HARDWARE IP NUMBERED)
Syntax [tcp|udp] access-list <3000-3699>
{copy-to-cpu|copy-to-mirror|send-to-mirror|deny|permit|send-to
-cpu} {tcp|udp} <source> {eq <sourceport>|lt
<sourceport>|gt
<sourceport>|ne
<sourceport>|
[range <start-range> <end-range>} <destination> [eq
<destport>|lt <destport>|gt <destport>|ne <destport>]|[range
<start-range> <end-range>]
no access-list <3000-3699>
<type-number> The ICMP type, as defined in RFC792 and RFC950. Specify one of
the following integers to create a filter for the ICMP message
type:
0 Echo replies.
3 Destination unreachable messages.
4 Source quench messages.
5 Redirect (change route) messages.
8 Echo requests.
11 Time exceeded messages.
12 Parameter problem messages.
13 Timestamp requests.
14 Timestamp replies.
15 Information requests.
16 Information replies.
17 Address mask requests.
18 Address mask replies.
Table 38: Parameters in the access-list (hardware IP numbered) command -
ip|icmp (cont.)
Parameter Description
Table 39: Parameters in the access-list (hardware IP numbered) command -
tcp|udp
Parameter Description
<3000-3699> Hardware IP access-list.
copy-to-cpu Specify packets to copy to the CPU.
copy-to-mirror Specify packets to copy to the mirror port.
send-to-mirror Specify packets to send to the mirror port.
deny The access-list rejects packets that match the type, source, and
destination filtering specified with this command.