C613-50100-01 REV C Command Reference for x930 Series 1866
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
ACCESS
-LIST (HARDWARE IP NUMBERED)
Syntax [proto] access-list <3000-3699>
{copy-to-cpu|copy-to-mirror|send-to-mirror|deny|permit|send-to
-cpu} proto <ip-protocol> <source> <destination>
no access-list <3000-3699>
<sourceport> The source (TCP or UDP) port number, specified as an integer
between 0 and 65535.
range Range of port numbers.
<start-range> Port number at start of range <0-65535>.
<end-range> Port number at end of range <0-65535>.
<destport> The destination (TCP or UDP) port number, specified as an
integer between 0 and 65535.
eq Matches port numbers that are equal to the port number
specified immediately after this parameter.
lt Matches port numbers that are less than the port number
specified immediately after this parameter.
gt Matches port numbers that are greater than the port number
specified immediately after this parameter.
ne Matches port numbers that are not equal to the port number
specified immediately after this parameter.
Table 39: Parameters in the access-list (hardware IP numbered) command -
tcp|udp (cont.)
Parameter Description
Table 40: Parameters in the access-list (hardware IP numbered) command -
proto
Parameter Description
<3000-3699> Hardware IP access-list.
copy-to-cpu Specify packets to copy to the CPU.
copy-to-mirror Specify packets to copy to the mirror port.
send-to-mirror Specify packets to send to the mirror port
deny Access-list rejects packets that match the source and destination
filtering specified with this command.
permit Access-list permits packets that match the source and
destination filtering specified with this command.
send-to-cpu Specify packets to send to the CPU.
To Next Page
Loading...
Need help?
General
