C613-50100-01 REV C Command Reference for x930 Series 2435
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
SHOW
COUNTER STACK
Related
Commands
show stack
switch provision (stack)
Link event Number of link event messages.
Reinitialise Number of reinitialize messages.
1-hop transport Number of 1-hop transport messages.
Layer-2
transport
Number of Layer 2 transport messages.
Topology error
counters
Reasons why a neighboring unit could not join the stack.
Version
unsupported
Number of stack software version unsupported errors.
Product
unsupported
Number of product unsupported errors.
XEM unsupported Number of XEM unsupported errors.
Too many units Number of too many units errors.
Invalid
messages
Number of invalid messages.
Health status
good
The number of times that the resiliency link has successfully
carried healthchecks following a failure at startup.
Health status
bad
The number of times that the resiliency link healthcheck has
timed out. A timeout occurs when a backup stack member
detects a delay greater than two seconds between
healthcheck messages received.
Rx The total number of healthcheck messages that a stack
member has received from the stack master.
Rx Error The total number of invalid healthcheck messages that have
been received from the master. This message is not applicable
to the stack master.
Table 1: Parameters in the output of the show counter stack command (cont.)
Parameters Description
To Next Page
Loading...
Need help?
General
