C613-50100-01 REV C Command Reference for x930 Series 2635
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF BACKUP
Node1#sh atmf backup server-status
Id Last Check State
-------------------------------------
1 186 s File server ready
2 1 s SSH no route to host
Table 55: Parameter definitions from the show atmf backup command
Parameter Definition
Scheduled
Backup
Indicates whether AMF backup scheduling is enabled or disabled.
Schedule Displays the configured backup schedule.
Next Backup Time Displays the date and time of the next scheduled.
Backup Media The current backup medium in use.
This will be one of USB, SD, or NONE.
Utilized and available memory (MB) will be indicated if backup media memory is
present.
Current Action The task that the AMF backup mechanism is currently performing. This will be a
combination of either (Idle, Starting, Doing, Stopping), or (manual, scheduled).
Started The date and time that the currently executing task was initiated in the format DD
MMM YYYY HH:MM
Current Node The name of the node that is currently being backed up.
Backup
Redundancy
Whether backup redundancy is enabled or disabled.
Local media The local media to be used for backup redundancy; SD or USB or NONE, and total
and free memory available on the media.
State Whether SD or USB media is installed and available for backup redundancy. May be
Active (if backup redundancy is functional—requires both the local redundant
backup media and a remote server to be configured and available) or Inactive.
Node Name The name of the node that is storing backup data - on its backup media.
Date The data of the last backup in the format DD MMM YYYY.
Time The time of the last backup in the format HH:MM:SS.
In ATMF Whether the node shown is active in the AMF network, (Yes or No).
On Media Whether the node shown has a backup on the backup media (Yes or No).
To Next Page
Loading...
Need help?
General
