C613-50100-01 REV C Command Reference for x930 Series 2657
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF LINKS DETAIL
Uplink Information Show all uplink entries.
• Waiting for Sync - Flag if uplinks are currently waiting for synchronization.
• Transaction ID - Shows transaction id of the local node.
• Number of Links - Number of up downlinks in the domain.
• Number of Local Uplinks - Number of uplinks on this node to the parent
domain.
• Originating Node - Node originating the uplink information.
• Domain - Name of the parent uplink domain.
• Node - Name of the node in the parent domain, that is connected to the
current domain.
• Ifindex - Interface index of the parent node's link to the current domain.
• VR ID - Virtual router id of the parent node’s link to the current domain.
• Transaction ID - Transaction identifier for the neighbor in crosslink.
• Flags - Used in domain messages to exchange the state:
ATMF_DOMAIN_FLAG_DOWN = 0
ATMF_DOMAIN_FLAG_UP = 1
ATMF_DOMAIN_FLAG_BLOCK = 2
ATMF_DOMAIN_FLAG_NOT_PRESENT = 4
ATMF_DOMAIN_FLAG_NO_NODE = 8
ATMF_DOMAIN_FLAG_NOT_ACTIVE_PARENT = 16
ATMF_DOMAIN_FLAG_NOT_LINKS = 32
ATMF_DOMAIN_FLAG_NO_CONFIG = 64
• Domain Controller - Domain Controller in the uplink domain
• Domain Controller MAC - MAC address of Domain Controller in uplink
domain
Downlink Domain
Information
Shows all the downlink entries:
• Domain - Name of the downlink domain.
• Domain Controller - Controller of the downlink domain.
• Domain Controller MAC - MAC address of the domain controller.
• Number of Links - Total number of links to this domain from the Node.
• Number of Links Up - Total number of links that are in UP state.
• Number of Links on This Node - Number of links terminating on this node.
• Links are Blocked - 0 links are not blocked to the domain. 1 All links are
blocked to the domain.
Table 63: Parameter definitions from the show atmf links detail command output (cont.)
Parameter Definition
To Next Page
Loading...
