C613-50100-01 REV C Command Reference for x930 Series 679
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
POWER OVER ETHERNET COMMANDS
SHOW
POWER-INLINE
Operational
Status
The operational status of the PSU hardware when this
command was issued:
• On if the PSU is installed and switched on.
• Off when the PSU is switched off (an RPS may be
connected to the switch to power PoE instead of the
PSU).
• Fault when there is an issue with the PSU hardware.
Power Usage
Threshold (%)
The configured SNMP trap / log threshold, as configured
from a power-inline usage-threshold command.
Interface The PoE port(s) in the format portx.y.z, where x is the
device number, y is the module number within the device,
and z is the PoE port number within the module.
Admin The administrative state of PoE on a PoE port, either
Enabled or Disabled.
Pri The current PoE priorities for PoE ports, as configured from
a power-inline priority command:
• Low displays when the low parameter is issued. The
lowest priority for a PoE enabled port (default).
• High displays when the high parameter is issued. The
second highest priority for a PoE enabled port.
• Crit displays when the critical parameter is issued.
The highest priority for a PoE enabled port.
Oper The current PoE port state when this command was issued:
• Powered displays when there is a PD connected and
power is being supplied.
• Disabled displays when supplying power would make
the switch go over the power budget.
• Off displays when PoE has been disabled for the PoE
port.
• F ault displays when a switch goes over its power
allocation.
Power The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
Device The description of the connected PD device if a description
has been added with the power-inline description
command. No description is shown for PDs not configured
with the power-inline description command.
Table 1: Parameters in the show power-inline command output (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
