Cisco Catalyst 2960 Series User Manual

CHAPTER 7 Configuring Boot Fast 81
Finding Feature Information 81
Configuring Boot Fast on the switch 81
Enabling Boot Fast 81
Disabling Boot Fast 82
CHAPTER 8 Configuring PoE 85
Finding Feature Information 85
Restrictions for PoE 85
Information about PoE 86
Power over Ethernet Ports 86
Supported Protocols and Standards 86
Powered-Device Detection and Initial Power Allocation 86
Power Management Modes 88
Power Monitoring and Power Policing 89
Maximum Power Allocation (Cutoff Power) on a PoE Port 89
Power Consumption Values 90
How to Configure PoE 91
Configuring a Power Management Mode on a PoE Port 91
Fast POE 92
Configuring Fast POE 93
Budgeting Power for Devices Connected to a PoE Port 94
Budgeting Power to All PoE ports 95
Budgeting Power to a Specific PoE Port 96
Configuring Power Policing 97
Monitoring Power Status 100
Configuration Examples for Configuring PoE 100
Budgeting Power: Example 100
Additional References 101
CHAPTER 9 Configuring 2-event Classification 103
Finding Feature Information 103
Information about 2-event Classification 103
Configuring 2-event Classification 103
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
vii
Contents

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000