C613-50100-01 REV C Command Reference for x930 Series 320
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PLUGGABLES AND CABLING COMMANDS
SHOW
SYSTEM PLUGGABLE DETAIL
Output Figure 8-5: Example output from the show system pluggable detail
command for a QSFP+ module
Output Figure 8-6: Example output from the show system pluggable detail
command for a QSFP+ DAC (direct attach cable)
awplus#show sys pluggable detail
System Pluggable Information Detail
Port1.1.1
==========
Vendor Name: ATI
Device Name: AT-QSFPSR
Device Revision: A
Device Type: 40GBASE-SR4
Serial Number: A04766R134100019
Manufacturing Datecode: 131010
SFP Laser Wavelength: 850nm
Link Length Supported
Single Mode Fiber : -
OM1 (62.5um) Fiber: -
OM2 (50um) Fiber : -
Diagnostic Calibration: Internal
Power Monitoring: Average
TX power monitor support: -
awplus#show sys pluggable detail
System Pluggable Information Detail
Port1.1.1
==========
Vendor Name: Methode Elec.
Device Name: DM-317-100
Device Revision: A
Device Type: 4xCOPPER PAS
Serial Number: 007868R13360360
Manufacturing Datecode: 13100101
Table 10: Parameters in the output from the show system pluggable detail
command:
Parameter Description
Stack member The stack member number.
Port Specifies the port the pluggable transceiver is installed in.
Vendor Name Specifies the vendor’s name for the installed pluggable
transceiver.
Device Name Specifies the device name for the installed pluggable
transceiver.
To Next Page
Loading...
Need help?
General
