Chapter 38: Per-Subscriber Throughput
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1015
Display QoS for CM IP Address
The following command is an example to display basic QoS information and verify throughput settings by using a specific
CM’s IP address:
show cable modem qos 10.142.31.238
Output similar to the following is returned by the system:
Sfid Dir Curr Sid Sched Prio MaxSusRate MaxBrst MinRsvRate Throughput packets/sec
State Type bits/sec
---- --- ----- ----- ----- ---- ---------- ------- ---------- ---------- -----------
15 US act 8199 BE 0 0 16128 0 830400 100
16 DS act 0 0 0 96000 0 830400 100
Display Verbose CM QoS Output
The following paragraphs provide examples for displaying verbose QoS parameter output (including throughput) for a CM’s
MAC and IP address.
Display QoS for CM MAC Address (Verbose)
The following command is an example to display verbose QoS information and verify throughput settings by using a
specific CM’s MAC address:
show cable modem qos 0015.d1bd.15c7 verbose
Output similar to the following is returned by the system:
Sfid : 15
Direction : US
Current State : Active
Sid : 8199
Traffic Priority : 0
Peak rate : 0 bits/sec
Maximum Sustained rate : 0 bits/sec
Maximum Burst : 16128 bytes
Minimum Reserved rate : 0 bits/sec
Minimum Packet Size : 16 bytes
Admitted QoS Timeout : 200 seconds
Active QoS Timeout : 0 seconds
Maximum Concatenated Burst : 16128 bytes
Scheduling Type : Best Effort
Request/Transmission policy : 0x00000000
IP ToS Overwrite [And-msk, OR-mask] : 0x00, 0x00
To Next Page
Loading...
