STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 386
Chapter 14
Cable-side Configuration
Overview .......................................................................................... 386
MAC Domains ................................................................................... 387
Upstream to Downstream Channel Association .............................. 405
Cable Plant Topology and Fiber Nodes ............................................ 411
Service Group Determination and Display ....................................... 416
Channel Sets ..................................................................................... 418
Receive Channel Configurations and Bonding Groups ..................... 427
Overview
This chapter discusses the configuration of the logical components that allow the C4/c CMTS to provide service to the
subscriber side of the system.
Once the Cable Access Modules (CAMs) and their channels have been configured, the C4/c CMTS must then be configured
to use these channels.
Note: For cable-side configuration to begin, it is assumed that the slots for all the operational CAMs have previously been
configured. If not, refer to Bring-up Procedures for specifics. Additional information on provisioning the CAM cards can be
found in the Downstream Cable Access Module (DCAM) and Upstream Cable Access Module (UCAM) chapters.
To Next Page
Loading...
