Arris C4C - Configure Access-List Tcp

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1209
configure access-list * tcp
Purpose
Configures an extended Access Control List (ACL) on the C4 CMTS if the protocol value is TCP.
Default Access Level
15
Command Syntax
configure access-list {<100-199> | <name>} <1-2147483647> <<permit | deny | remark | resequence> tcp
{<src-ip> <wildcard bits> | host <src-ip> | any} [{eq | gt | lt | neq} {<port1> | range <port1> <port2>}
[dscp <0-63>] [precedence <uint>] [tos <0-15>] [fragments] [established] [urg] [ack] [psh] [rst] [syn]
[fin]
configure access-list {<100-199> | <name>} <1-2147483647> <permit | deny | remark | resequence> tcp
{<src-ip> <wildcard bits> | host <src-ip> | any} [{eq | gt | lt | neq} {<port1> | range <port1> <port2>}
[dscp <0-63>] [precedence <uint>] [tos <0-15>] [fragments] [established] [urg] [ack] [psh] [rst] [syn]
[fin] no
Supplemental
Information
To remove an extended ACL, use the no option.
Parameters
<100-199>
The extended ACL numeric identifier of the access list. This is a number from 1-99.
<name>
Access list name
<1-214748364>
Access list index number.
<permit | deny |
remark |
resequence>
permit: Permits access if the condition is matched.
deny: Denies access if the condition is matched.
remark: Access list entry comment
resequence: Resequence the access list index numbers