Arris C4C - Configure Ipv6 Neighbor Link-Aggregate

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2117
configure ipv6 neighbor * link-aggregate
Purpose
Creates or deletes a static entry in the neighbor discovery (ND) cache for a link-aggregate interface using the MAC address.
Default Access Level
15
Command Syntax
configure ipv6 neighbor <ipv6 address> link-aggregate <0-9[.0-254]> <mac-address>
configure ipv6 neighbor <ipv6 address> link-aggregate [<0-9[.0-254]>] [<mac-address>] no
Supplemental
Information
To remove the neighbor, use the no option.
Parameters
<ipv6-address>
The address of the neighbor. It is in hexidecimal using 16-bit values between colons.
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<mac-address>
The 48-bit ethernet address used to address the node on the interface.