Arris C4C - Configure Arp State Searching Max-Number

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1239
configure arp state searching max-number
Purpose
Sets the maximum number of ARP requests transmitted for an ARP entry in the searching state.
Default Access Level
15
Command Syntax
configure arp state searching max-number <number>
configure arp state searching max-number [<number>] no
Supplemental
Information
Sets the maximum number of ARP requests transmitted for an ARP entry in the searching state. After this number is reached, the
next request causes the entry to transition to the notPresent state.
To reset the maximum number to the default value, use the no option.
Parameters
<number>
Maximum number of ARP requests sent in this state. Range is 0 to 65535 and the default is set at 3 requests.
Related Commands
configure arp state not-present max-number (page 1232)
configure arp state not-present max-time (page 1233)
configure arp state searching rate-limit (page 1240)