Arris C4C - Сonfigure Interface Cable-Mac Ipv6 Nd Prefix

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1655
configure interface cable-mac * ipv6 nd prefix
Purpose
Sets the lifetime and advertisements for prefix.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac[.0]> ipv6 nd prefix <word> [<sec>] [<sec2>] [off-link]
[no-autoconfig] [autoconfig]
configure interface cable-mac <mac[.0]> ipv6 nd prefix <word> [<sec>] [<sec2>] [off-link]
[no-autoconfig] [autoconfig] no
Supplemental
Information
Note: Site-local traffic of CPEs behind different modems is not bridged. Neighbor Discovery Proxy is not supported. These CPEs can
communicate if their interfaces are configured with off-link prefixes.
To remove the lifetime and advertisements for prefix, use the no option.
Parameters
<mac[.0]>
The MAC identifier and optional sub interface.
<word>
Prefix/prefix length
<sec>
Valid lifetime in seconds
<sec2>
Preferred lifetime in seconds
[off-link]
Indicates prefix is not locally reachable by hosts and must be routed. All packets with this prefix as the destination to the CMTS
acting as a router will be forwarded.
[no-autoconfig]
Indicates host may not use prefix for auto-configured IPv6 address
[autoconfig]
Indicates host may use prefix for auto-configured IPv6 address