Arris C4C - Configure Ntp Server Broadcast

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2200
configure ntp server * broadcast
Purpose
Configures the CMTS to be an NTP broadcast client listening to some NTP broadcast server that is periodically sending time sync
within the broadcast subnet identified by the specified IP address.
Default Access Level
15
Command Syntax
configure ntp server <ip address> broadcast
Supplemental
Information
CAUTION: To avoid loops, do not use this mode if the C4 CMTS is also configured to be a Broadcast or Multicast Server.
Parameters
<ip-address>
The form of the broadcast iP address may be A1.255.255.255, B1.B2.255.255, or C1.C2.C3.255. In addition, the IP address
255.255.255.255 identifies the local subnet to which the C4 CMTS is attached.