Arris C4C - Show Running-Config Interface Ethernet

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3026
show running-config interface ethernet
Purpose
The show running-config interface command shows the parameters for the specified System Controller ethernet interface.
Default Access Level
15
Command Syntax
show running-config interface ethernet <slot>/0 [verbose] [linenum] [full]
Supplemental
Information
N/A
Parameters
<slot>/0
The chassis slot number of the System Controller Module. Valid range for the C4 CMTS is 19-20; valid range for the C4c CMTS is
19. The only valid port value is 0 (zero).
[verbose]
Displays the output with ‘configure’ on each line.
[linecard]
Enumerates each line with its line number in the output.
[full]
Displays all configuration values, including default values.